Call now to get tree help just as tree clearing, tree notch, bush cutter, shrub trimmers, stump disposal and plenty more across United States.


Call us

Call us +1 (855) 280-15-30










Do not start grinding in the middle of the stump; start grinding.

Repeat steps 4 through 8 until you reach the right side of the stump. Return the grinder to the left side of the stump, lower it, and repeat steps 3 through 10 until you have ground the stump into the ground. Note: To contain the chips, you may need to stop the grinder and move the chip guard up as you move the grinder stumpcutting.buzz: 79 cm (31 inches). It is a violation of California Public Resource Code Section or to use or operate the engine on any forest-covered, brush-covered, or grass-covered land unless the engine is equipped with a spark arrester, as defined in Sectionmaintained in effective working order or the engine is constructed, equipped, and maintained for the prevention of stumpcutting.buzzg Depth: 30 cm (12 inches).

Replace drive belt.

Ensure Cutting Depth: 30 cm 12 inches.

Adjust tension of new belt to 8 kg (18 lb) force and 10 mm ( inch) belt deflection at mid-span. Tighten the 4 engine-plate mounting bolts and the 4 bolts securing the rear of the belt guard to the engine.

Install the belt guard and secure it with the previously removed washers and stumpcutting.buzzg Depth: 30 cm (12 inches). Some dedicated stump grinders are over-complicated. Not the Toro STX. Its patented Toro Dingo TX-style control system has pruning tall trees, 81416 Delta CO simple levers that are simple to learn, master and use.

Combine these easy-to-use controls with tracks and transport speeds exceeding 4 mph, and you get maximum productivity. 12 tungsten, carbide tipped teeth handle the most difficult stumps. Positioned between handle and frame reduces vibration resulting in less operator fatigue.

Equates to less “muscling” machine while cutting. Allows for easy compact transport in back of SUV, car trunk, or mini van. Durable clutch to handle abuse of stump impact. Read the Operator’s Manual. Warning, cutting wheel- to adjust the cutting wheel teeth between jobs 1) Loosen the nut; 2) Push the tooth down and rotate it 1/3 turn; 3) Tighten the nut to 68 Nm (50 ft-lb); 4) Proceed with grinding.