Sep 19, OK, got my bushing removal/install tool today from Koch and here's a few thoughts about it. I installed my front lower control arm bushings but even using this tool, per the instructions, I still had to hacksaw off the lip on the front aluminium bushing in order for the tool to rest in the correct place to remove the stumpcutting.buzzted Reading Time: 8 mins. OEMTOOLS Manual Bushing Installation and Removal Tool Set, Bushing Removal Tool, Bearing Press Kit, Bushing Tool Kit, Tool Kit Push Pull Bushing.
out of 5 stars 9TRADING Mercedes Benz W W W Ball Joint Press Installer Removal Kit Tool C-Clamp. out of 5 stars 3.
Sep 05, Paulo: Comments: What bushings for the sway bar do you use, since the w sway bar has the bushing attached to the sawy bar from factory? Regards: June 20, Followup from the Pelican Staff: There are a few aftermarket solutions, including H&R. Give our parts specialists a call at They can help you find the right part. - Nick at Pelican Parts. 1. Shift rod clip tool; 2.
Bushing removal and installation tool; 3. 2 new nylon bushings - (comes with a pouch of synthetic grease) 4. PDF Instructions; White bushing measures: (In the groove) mm OD, mm ID, width mm. Here is what happens to these bushings when they get old and tired. Aug 14, When pushing the new bushing in, I used a 50mm cup from a ball joint tool kit.
That's what caused the damage on one of the bushings because it was very hard to align the cup perfectly perpendicular over the bushing outer shell. My advice to you is to to use a proper bushing tool kit.
Bear in mind that when the bushing is fully inserted in the.